stefan.markovic3539

the entire model’s done, I didn’t upload any updates in the meantime because I was very bussy with this and I had my wisdom teeth removed which made it harder to focus. Everything is there, but I don’t think that I’ll have the time to integrate something with music. I just don’t have any space left in the model for a buzzer or something, and I’m concerned that an extra component will fry my arduino. The only think left is programming the arduino and then I’m done!

I rescaled the heart a bunch of times, but finally decided on 100x100mm, which’ll probably be big enough but not too big, which could lead to the LEDs not having much of an impact. Also added holes for said LEDs.

I finished this heart model in onshape. This is the bare minimum for what I want to give her, but I’m planning on putting some holes near the edges of the model that can fit LEDs which could be put in blinking mode or just turned on. She also likes music a lot so I’d like to incorporate that in this project aswel, I just don’t know how. Suggestions will definitely be appreciated. How can the LED holes be made efficiently around the edges of the heart without mannually having to place them all, is this even possible?
I also need to link hackatime with the arduino IDE but I have no idea how, does anyone have a clue?